The original gauge was a cheap plastic unit that was starting to crack. It had served many years, repairs to the lanai required its removal. The board it was fastened to was beginning to rot and needed to be replaced. The plumeria were overrunning its location as well, blocking the rain.
A glass tube rain gauge ordered on eBay was the starting point. The cheap stamped aluminum base just begged to be replaced with something better. A few minutes of thought and an idea was formed. Off to the garage with the tube of glass, rummaging through the stash of supplies commenced.
The holder was assembled with the same skills and tools I use for constructing and repairing electronic devices. Copper wire and solder, with thin brass alloy used for the leaves.
A couple hours bending and twisting the wire, soldering each joint as I went. A section of one inch copper pipe stood in for the fragile glass tube during forming. Twisted wire and little metal leaves… Much classier than the stamped aluminum base supplied with the gauge.
Who says engineers are not artistic!